« previous next »
Pages: [1]

Author Topic: odd y axis issue  (Read 110 times)

6Firewall6

  • Newbie
  • *
  • Posts: 27
    • View Profile
odd y axis issue
« on: December 02, 2019, 06:59:56 PM »
Odd issue after an update to 1.5y in T2. When I try to engrave anything the Y axis shows the full number of steps but the carriage only goes for half the distance. the X axis has no issues has anyone else seen this?
Logged
2.5w laser A3 size
Mana SE board

ggallant571

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2938
    • View Profile
Re: odd y axis issue
« Reply #1 on: December 02, 2019, 07:13:55 PM »
Is it "exactly" half the distance? Have you looked at the grbl parameters? Version 1.5y of what? Have you tried a simple square with raw gcode?
Logged
SARCASM - Just one more service we offer here.

6Firewall6

  • Newbie
  • *
  • Posts: 27
    • View Profile
Re: odd y axis issue
« Reply #2 on: December 02, 2019, 07:24:45 PM »
I did try that. I had also asked on the discord and  Thothloki found the issue the y axis was set for 35 not 80
Logged
2.5w laser A3 size
Mana SE board

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6852
    • View Profile
    • T2Laser
Re: odd y axis issue
« Reply #3 on: December 03, 2019, 04:53:03 AM »
Glad you got it fixed, there's a calibration menu that will adjust the steps for your machine if needed.

FYI: That wasn't due to a T2Laser update, I never change Grbl parameters without the user clicking to request it.
Logged
Pages: [1]
« previous next »