Benbox Laser DIY Machines

General Category => Engraving => Topic started by: imatoso on November 19, 2016, 09:48:42 AM

Title: Benbox carve mode outline polyline do not work with bmp.
Post by: imatoso on November 19, 2016, 09:48:42 AM

I was able to do once the figure of the Mario Bros in the benbox using outline polyline or curve, this configuration no longer works, the laser does not work with bmp figures, when I activate the delimiter it only makes the rectangle in the size of the figure. Someone with similar experience. Thank you, Ivo Nunes Brazil.
Title: Re: Benbox carve mode outline polyline do not work with bmp.
Post by: cottoncb on January 09, 2017, 06:44:49 AM
This may not be your issue, but I have had to "open as administrator" in order to get it to work sometimes with BMP
Title: Re: Benbox carve mode outline polyline do not work with bmp.
Post by: Madmark on January 11, 2017, 03:53:34 PM
Try setting the .bmp DPI = 254 or 100 per cm

Make sure the sizes are multiples of 8.

M
Title: Re: Benbox carve mode outline polyline do not work with bmp.
Post by: ed57 on January 19, 2017, 10:56:12 AM
I had the same problem, using Benbox version 3.7.99.  I loaded Benbox version 3.6.96 ,  and now the outline function works fine. My OS is windows 10.