Benbox Laser Machines/CO2 Lasers/3D Printers

Software => T2 Engraving => Topic started by: Stonemull on April 25, 2018, 09:49:35 AM

Title: Minor bug on exit
Post by: Stonemull on April 25, 2018, 09:49:35 AM
Not sure if it has been mentioned, got me twice so far .. "are you sure you want to exit without saving" .. traditionally hitting "cancel" takes you back to the software, not exits :)

I just did a perfect PCB, forgot to save the profile or note the settings, doh!


Title: Re: Minor bug on exit
Post by: Zax on April 25, 2018, 02:11:53 PM
Thank you for pointing that out, I use Silent Mode so never get the warning messages.

Added to the list.