Benbox Laser Machines/CO2 Lasers/3D Printers

General Category => Projects => Topic started by: Tug Wilson on March 19, 2019, 09:01:36 AM

Title: place mats of distinction
Post by: Tug Wilson on March 19, 2019, 09:01:36 AM
I have been making these and many other s like them for our military brothers, thought you would like to see them. Tug
Title: Re: place mats of distinction
Post by: Zax on March 19, 2019, 09:51:31 AM
Very nice! Do you clear coat or laminate them so they will last?
Title: Re: place mats of distinction
Post by: nottingham82 on March 19, 2019, 06:13:02 PM
Nice

Sent from my moto z3 using Tapatalk

Title: Re: place mats of distinction
Post by: Tug Wilson on March 23, 2019, 05:45:20 AM
sorry for the delay Zax, been up to my eyes in getting orders out. yes I use vehicle lacquer spray cans it's the same stuff on cars, so heat resistant water and grease too. I hand paint the colours on before coating which seals in the paint.
the units have gone well and the flasks are flying off the shelf so all good this end.
regards Tug