Benbox Laser Machines/CO2 Lasers/3D Printers

Software => T2 Engraving => Topic started by: jmarsden92 on December 30, 2019, 08:52:24 PM

Title: Wife got a engraver for XMas...
Post by: jmarsden92 on December 30, 2019, 08:52:24 PM
I bought my wife a engraver for XMas.
It has
NANO
DCCduino
printed on the outer chip

I run T2 but it only allows printing of a few lines when I import a picture...
Is this because it is in demo mode?
Title: Re: Wife got a engraver for XMas...
Post by: Zax on December 31, 2019, 04:19:19 AM
It sounds like you bought yourself a laser for Xmas  ;D

The trial is limited to 10,000 lines of G-code, which using a resolution of 0.15 to 0.2 should be sufficient for testing that everything works correctly. The registered version removes all restrictions of course, currently $39.95 if purchased from the trial ($5 discount).