Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - djmartins

Pages: [1]
1
T2 Engraving / Re: T2 Enhancement requests
« on: July 30, 2020, 12:07:40 PM »
I believe GRBL is up to 1.1h now, is there any advantage to going to 1.1h (2019/08/25 - bugfixes and new dual motor support)
and will you add it to T2Laser?
Bugfixes are mostly coolant/safety door stuff not relevant to laser engravers though maybe one could use the coolant signal
to a relay to turn on air assist.
I understand if you haven't tested it and want to play it safe with the "if it isn't broken, don't fix it" approach.


Pages: [1]