Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - heike1

Pages: [1]
1
Benbox / Re: Benbox script error
« on: January 18, 2019, 11:03:40 AM »
No information on why the error is occurring. I can still use the outline function as before but the laser stops and it seems I cannot control the burn intensity anymore

2
Benbox / Benbox script error
« on: December 16, 2018, 06:04:50 AM »
Morning
I am receiving a script error when I start Benbox.  I am running benbox V3.7.99 on windows 10.  My laser is the EleksLaser-A3 Pro 2500mW.  This error started about three weeks ago and prior to that everything was working fine. Tried uninstalling and reinstalling and same error shows up.  Another symptom that is now occurring is the laser will freeze during burning, I move the mouse around and it starts up again.  If I don't pay attention sometime when it stops the laser doesn't stop and continues to burn the single point.  Attached is a screen shot of the error

Pages: [1]