Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jym

Pages: [1]
1
MegaPi / Re: limit endstop megapi with grbl
« on: March 29, 2020, 01:32:18 AM »
Please

Anyone know?

thanks

2
MegaPi / limit endstop megapi with grbl
« on: December 27, 2019, 01:38:29 AM »
Hi,

How can I enable the limit switch with this Firmware: https://github.com/renebohne/grbl-laserbot.

It work great with many software, but I need to enable the limit switch for homing.
in Readme.md, i see it is in a6-a7, but when I make it on GND-SIG, it do nothing.

Can you help me?

Thank

3
T2 Engraving / Re: T2 and Laserbot
« on: November 24, 2019, 07:00:27 AM »
Ok,
Laserbot is ok with Mlaser and firmware integrated in Mlaser
Laserbot is ok with Bencutlaser and firmware Marlin 110 RC8 FA BL

But not working with T2.
I think this is not T2 of course, but the parameters and/or firmware.

4
T2 Engraving / Re: T2 and Laserbot
« on: November 24, 2019, 06:31:48 AM »
Yes, but with firmware 1.1f mega 2560, laser is always on. No motor action.

5
T2 Engraving / T2 and Laserbot
« on: November 24, 2019, 02:53:21 AM »
Hello

I have T2 in trial mode.
What firmware can i use with laserbot ( megapi) .
Actually i use bencutlaser  (trial too) and this is good.

Thank you

Pages: [1]