Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Maurizio

Pages: [1]
BenCutLaser / Re: error when loading dxf file (Open)
« on: December 19, 2019, 01:56:05 AM »
Thanks a lot. I load my draw in QCAD and I save it as a new file... I works in Bencutlaser.
After a reload my original file in QCAD I convert all lines in Polylines and I save it.
I load that in Bencutlaser and.... GREAT! I save a lot of times now..

Thanks again.

BenCutLaser / error when loading dxf file (RESOLVED)
« on: December 17, 2019, 08:50:05 AM »
I am trying bencutlaser and I got error message when loadin some dxf files. I using the trial version  (vers. 1.7.9)
This is the message I got.

.DXF File Load Error
430 Exception Message:The knot tolerance must be greater than zero.
Nome parametro: value
Valore effettivo: 0.

Not ALL dxf have this problem

I attach the dxf

Can someone help me?
Thanks a lot...

Pages: [1]