Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - monkfood

Pages: [1]
1
T2 Engraving / T2 + EleksLaser "Unable to PRocess Status Message"
« on: December 22, 2018, 01:07:23 PM »
In a non-deterministic way i get "Unable to Process Status Message" from the T2 software.
The laser just stops at the last command it got.
I already tried
- setting simple communication mode, but that did not solve the problem,
- i have no screensaver or sleep mode.
- i reflashed the 1.1e firmware

it can not be the gcode i use because it works sometimes and sometimes it does not....

quite frustrating.
any ideas? Or do you know what the origin of this messag is?

Thanks
Monkfood

Pages: [1]