Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zukny1

Pages: [1]
1
T2 Engraving / 45 degree Angle Troubles
« on: April 23, 2019, 06:11:59 AM »
So yesterday I printed a small piece at 45 degree angles and it came out amazing.  Today I did it and it's coming out like crap.  I have gone back and re-tightened all of the motor teeth up.  I am wondering if anyone thinks it could be something else.

2
Engraving / Large Engraving
« on: April 19, 2019, 08:45:51 AM »
I'm working on a fairly large engraving and the engraving is really divided up into 3 areas. (top) (middle) and (bottom).  There are wide open areas on some of the wood that don't require any engaving at all.  So basically it will engrave (.2 inches) at the bottom. Then scroll all the way to the top and engrave another (.01 inch) for the next item.  Is there a  way to have the engraver concentrate on designated areas.  It would be great if i could highlight sections to be engraved first second and third, etc..

My concern is that the engraver running around this much will loosen it's bolts and possibly mess up half way through.  When it's all engraving closer, there is more working and less running back and forth.

Pages: [1]