Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jym

Pages: [1]
1
MegaPi / limit endstop megapi with grbl
« on: December 27, 2019, 01:38:29 AM »
Hi,

How can I enable the limit switch with this Firmware: https://github.com/renebohne/grbl-laserbot.

It work great with many software, but I need to enable the limit switch for homing.
in Readme.md, i see it is in a6-a7, but when I make it on GND-SIG, it do nothing.

Can you help me?

Thank

2
T2 Engraving / T2 and Laserbot
« on: November 24, 2019, 02:53:21 AM »
Hello

I have T2 in trial mode.
What firmware can i use with laserbot ( megapi) .
Actually i use bencutlaser  (trial too) and this is good.

Thank you

Pages: [1]