Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - taz101

Pages: [1]
1
T2 Engraving / round canvas
« on: June 11, 2020, 02:36:15 AM »
Hi All,
I use T2Laser and I have alignment problems. When I try and burn a round object the alignment is always off. It does not matter if I do lower left or center alignment it is always wrong.
Is there a way to create a round canvas? I don't have a problem with square or rectangle projects.
Thanks in advance for any help.
Paul

2
Other Software / Time remaining clock
« on: June 05, 2020, 02:21:49 AM »
Hi,
I am using T2Laser to learn laser engraving and so far so good. My question is can I adjust or reset the count down clock (time remaining). When the job starts it will say 19 min. but an hour later it is still working.
Some times it may be off by an hour or more or just a few minutes.
Do I have something set wrong?
Thanks for your help
Pal

3
T2 Engraving / connecting laser
« on: May 28, 2020, 02:50:11 AM »
Good Morning,
I just received my new Eleksmaker 2.5w laser and can't figure out how to connect it. The Eleksmaker Mana has a 3 prong connector for the laser and the laser has the same connection. My problem is there is no connection for the power supply (the module that came with the laser) with 3 wires. No voltage rated and no place to connect it. See attached photo. I don't want to screw it up.
Thanks for any help.
Paul

Pages: [1]