Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - cazz

Pages: [1]
Is that any free simulator that can show some kind of result how it going to look when is finnish?

When I use my CNC mill I use CAMotics, but when I for fun open the g-code that is create with T2Laser it does not show show much more then where it going to burn.

I did try to engraving a picture today and notice when it was finnish that the picture maybe was to bright so most of the head did not show (did not burn there)
so I was hoping it was some software that can tell me how it going to look.

Engraving / Curious about acrylic engraving
« on: August 24, 2020, 08:22:14 AM »
I have T2Laser software and a 2W Laser that I engraving in wood and most if the time it works fine (I'm new to laser so I have not done so much yet)
I have been curious about acrylic engraving so I have search here and other places and I get different answers but I maybe misunderstand what they mean.

So run fast/slow and power high/low (the new version of T2Laser show it in procent)

I plan to test something later in the week but would be happy if anyone has suggestions what to start with or recommend any settings for 3mm acrylic

The acrylic I have have no paper just a small transparent plastic cover

T2 Engraving / Does T2Laser have error log?
« on: August 23, 2020, 11:34:04 AM »
I have try to burn three things this weekend but only one succeed
Two of them give me

Error Detected!
Sending Aborted

Not sure why it does this.
I running the 1.1e that I upload from the program.

The sad thing is that the work takes 6 hours to drive but the error comes when there is only 10 percent left.

Maybe is the cable I don't know so I was wonder if the log show any error.
I can try again tomorrow with another cable but when it take 6 hour and don't know if it going to work or not then is not so fun.

T2 Engraving / New user have three questions
« on: August 16, 2020, 04:48:58 AM »
I have just buy the software and I like it alot but I have three questions

1) Can I see somewhere calc how long time is going to take from start to finnish? Right now I just see procent but like to have time too so I know how long is going to take.
2) Is it anyway I can see how big wood I need to have to use. I mean is it possible to make the software run a frame with so low power so it does not burn but I can see where is going to be.
3) What I read from manufacture is a good idea if the work is going to take over a hour it cool down 15 min before continues. I don't know how long some engraving can take but if that is possible to if the software notice this is going to take more then a hour it take a brake about 15 min before continues.

Benbox / Just a burn line and no shape or text
« on: August 14, 2020, 11:42:02 AM »
I have bought a cheap laser machine that I plan to engrave a bit with.
Not sure if that is the problem I have but the seller har write that I will never upgrade the firmware.
I guess if I do that the software stop working or something.

The problem I have is it just burn a line in the wood and no shape or text from the example it was with the software
A text that say Benbox and a ruler both give me a burn line but I can see the laser go on and off
I have take some screenshot of the settings but not sure if that is the problem

Pages: [1]