Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mikeCAD

Pages: [1]
1
T2 Engraving / Laser Speed
« on: July 30, 2017, 12:34:36 AM »
Dears,

yesterday I made my first try (one year after  I bought it ;-)

It seems that the speed settings have not a big influence in the speed the laser does - it is very slow.
Is there somewhere a setting which limits the speed to a other value than in T2 is indicated?

Thanks a lot

2
T2 Engraving / Zero-point
« on: October 21, 2016, 09:12:05 AM »
Dears,

I've a question accoring zero of sketch.

Is there a possibility to put the zero point in the middle of the sketch area?
Background:
If I mill the outline of something, lets say a rabbit and I want to engrave the eyes, nose and so on with the laser I need a defined point on the rabbit.
When the zero point is in the corner, I would also need the point of the rabbit in the lower left corner - but due to the shape of the rabbit, there couldn't be any point of it.
Hope someone could understand what I mean?!

Thanks for your help

3
T2 Engraving / Features / Screenshots of T2
« on: September 06, 2016, 10:40:14 AM »
Dears,

I'm very new in lasers - so sorry for my newbee questions.
I'm interested in T2 - also because of the german translation ;-)

So - i read already the manual, but there are still a few questions:
Is it possible to cut with T2 in more than one run?
Can I mark lines for engraving and other ones for cutting?
Does someone have some screenshots of the program (they seems to be very rare= ;-)

Thanks very much for your help!

BR

Michael

4
Other Software / RD Laserwork
« on: August 28, 2016, 12:05:12 AM »
Hello all,

I'm new here and my laser is still on the way from china.
At the moment I'm looking for the right software. I found "RD Laserwork" (some china-laser use it).
Does it also run on arduino? Has someone experience with it?

Thanks and best regards

Michael

Pages: [1]