Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tillerswife

Pages: [1]
1
Trouble Shooting / Re: Microsoft .net framework warning!! Help!!
« on: March 11, 2019, 08:27:13 AM »
Thank You!  That worked!!!

Crazy how quickly something can mess up. 

2
Trouble Shooting / Microsoft .net framework warning!! Help!!
« on: March 11, 2019, 07:12:47 AM »
Aackkk!  Had no issues using it the past few days and all of a sudden that pops up this morning.  How do I deal with this issue?  :/

Machine boots up, Laser comes on, but T2Laser won't do anything :(

Thanks!


3
Spare Parts Sources / Longer Rails, Extending Wires
« on: February 27, 2019, 04:26:04 PM »
Howdy.  Am curious about extending my workspace....we have the 65x50cm ebay machine but the inside work space is a lot smaller.  He is wanting a couple of pieces that are around 48 inches long.  Where's the best place for longer rails and wiring extensions for the workspace?  If we can't find them, I am going to have a challenge of working what he wants in steps.  Lining up precise points .... always fun!  ;)

Thanks in advance!

4
T2 Engraving / Re: View While Engraving?
« on: February 23, 2019, 07:06:36 AM »
 :P :D wasn't sure and asking is better than having more wisdom highlights happen.  lol

5
T2 Engraving / View While Engraving?
« on: February 23, 2019, 06:17:15 AM »
Is there a way to view the work as it engraves?  I know you can view before or after, but I can't figure out if I can do so as the laser is in motion.    If not, it's cool.  One of the little things I will obsess over until I know.  haha  ;) 

thanks in advance!!

6
T2 Engraving / Re: Engraving Mirrors (back)
« on: February 22, 2019, 03:57:30 PM »
I am all about the budget-friendly mirrors. ;)
I will try the lower resolution setting.  Thank You! 

7
T2 Engraving / Engraving Mirrors (back)
« on: February 22, 2019, 03:25:21 PM »
Hiya.  We purchased an EBay Laser Engraver.  The pamphlet was horrible but we figured it all out and I finally got Benbox to work out.  I played with acrylic, mirror and wood.  The mirror turned out very nice for the few options Benbox offered.  Just installed the T2 the other evening and have been playing with wood.  I tried a small image on mirror and went over it numerous times before it would show up.  Does anyone have a decent setting for mirror?  I have come across numerous for wood and acrylic.....thanks for those! :)

I'll attach the mirror I did with benbox.  Pops in law loved it.

Pages: [1]