Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Eojuk

Pages: [1]
Assembly Help / Re: Assembly Reference Video
« on: January 07, 2017, 02:54:41 PM »
I found this one, it's not in English but it's a good how to

T2 Engraving / Re: T2 Test version
« on: January 04, 2017, 09:31:32 AM »
Well that depends which firmware you are using  ;D ?

If you followed my conversion4.pdf document and have T2Laser v1.3t then you should be using Grbl 1.1e in which case you can reverse the axis in the menu.

Hi Zax
I did follow your instructions, I've found the reverse the axis in the menu.
The 1st time I ran the software, the axis where ok. Don't know what I've done, so sorted now thanks

T2 Engraving / T2 Test version
« on: January 04, 2017, 05:51:25 AM »
Hopefully I'm not asking the same question, I do apologise in advance if I have .

Yesterday I got my EleksMaker EleksLaser-A3 Pro 2500mW Laser Engraving Machine CNC Laser Printer (1003863)

The control buttons work but in the wrong directions.
Do I need a different firmware?

Pages: [1]