Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - mrehmus

Pages: [1] 2 3 ... 5
BenCutLaser / Upgrade Installation woes (CLOSED)
« on: October 24, 2018, 06:08:54 PM »
I had BCL 2.3a running nicely on an old 32 bit XP laptop. Attempted to upgrade to 3.2 and the installation failed.
First the setup.exe file (only) will not extract using PeaZip to unzip the files into a new directory. I could copy it from the zip file to the location of the other BCL files in a new folder.

The installation has a problem at the end where it states it cannot find the uninstall file. However, the install program signals success.

Attempting to run 3.2 brings up an error message that 3.2 is not a 32 bit program. I cannot find, in the forum release files, where BCL is now only a 64 bit program.

I reinstalled from a new download and installed BCL directly from the zip file with the same results.

BCL 2.3 runs nicely in my Win10 Pro machine.

Any ideas?

Inspiration / free book on laser cutting/engraving
« on: January 13, 2018, 06:33:56 PM »

They want your name and e-mail address but the book looks useful.

Inspiration / Another source
« on: January 05, 2018, 09:58:14 AM »

General Discussion / Take a look at this cheap and easy cable chain.
« on: December 22, 2017, 01:46:22 PM »

You can get a cheap tape measure at Harbor Freight. Sometimes they are even free with another purchase.

General Discussion / 40 watt $400 lasers
« on: November 08, 2017, 08:32:26 PM »
Has anyone actually been able to make one of these work dependably without spending a lot more money and time on them? That is, do they work out of the box after mirror alignment, etc.

Inspiration / More nice ideas
« on: November 07, 2017, 06:42:43 PM »

Pages: [1] 2 3 ... 5