Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 6Firewall6

Pages: 1 [2]
16
General Discussion / Re: Longer legs
« on: December 30, 2018, 01:00:09 PM »
Thanks. What I was thinking about is just replacing the acrylic parts with some angle iron. Do you know what the Max focus distance is the for the lasers? I want something I can just bolt in and not have it move. I have to move the laser box quite often due to it being in my living room right now till i get a new shop built.

17
General Discussion / Longer legs
« on: December 30, 2018, 12:36:13 PM »
I am thinking about building longer legs for my unit to allow it to use the rotary I had printed  and then go back to normal use with out having to move the unit each time. I have it mounted in side of a box i built to hold everything and bolted down whit l brackets right now. Is that any issue whit the framing being further away from the project for normal engraving use? Here is my current set up.

18
Engraving / Re: Engraving a Mirror
« on: December 19, 2018, 07:15:15 PM »
Here is the first on i got done  will work on the next on Saturday when I have the time needed for the burn.

19
Engraving / Re: Clocks.
« on: December 17, 2018, 05:56:12 PM »
Can you post the file you used for the falcon clock. I have a buddy that would love that.

20
Engraving / Re: Engraving a Mirror
« on: December 17, 2018, 05:21:07 PM »
New board showed up today and I am still seeing the issue on bi directional but it looks good on single. I am going to do a test mirror on that setting to see how it turns out and if it looks good i will do the present ones. Then I can work more on getting the bi directional working right. I will do two passes at 850 ans see how it turns out.

21
Engraving / Re: Engraving a Mirror
« on: December 10, 2018, 04:28:14 PM »
I think I got the carriage set up right now but unfortunately when I went to test I got a power surge and now I have burnt traces on the control board and the motors wont work. I have a EleksMana SE on order but it has not shown up yet.

22
Engraving / Re: Engraving a Mirror
« on: December 09, 2018, 07:09:48 PM »
I ran the nested lines image that was in a different thread and had a wiggle in both normal and no bi directional mode. I have new belt holders that a friend printed for me i am going to put on and see if I can get the belt fixed and the then work on the wheels.

23
Engraving / Engraving a Mirror
« on: December 08, 2018, 05:11:45 PM »
I am planing on doing backlit engraved mirrors for my nieces for Christmas and since my new 2.5w module showed up I started testing to check the settings I would need based on what I have read on here. I ran the image at Speed:1500 Power:255 in T2 laser. I only did one pass and when  pulled the mirror out of my encloser i could see were it had engraved the back of the mirror but not in both layers. Do i need to go slower or do multiable passes?


24
LaserGrbl / Swaping Y axis
« on: November 25, 2018, 08:59:27 PM »
I have tried to use this program with my Engraver and the Y access is set the wrong way for me. Is there any way in the program to swap the y axis? I know I can in T2  and in Elekcam . I have not tried any other software yet.

Pages: 1 [2]