Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jmarsden92

Pages: [1]
Custom Size Frames / Question...
« on: January 08, 2020, 07:16:43 PM »
I have a 65x50 cm laser engraver with blue laser...  the board is a DCCduino...  It has a 2 wire connector on the board that leads to the laser power module...  I just purchased a eleksmaker mana se.  I wanted to go to that board, but the laser is a 3 wire on the board...  suggestions?

T2 Engraving / Wife got a engraver for XMas...
« on: December 30, 2019, 08:52:24 PM »
I bought my wife a engraver for XMas.
It has
printed on the outer chip

I run T2 but it only allows printing of a few lines when I import a picture...
Is this because it is in demo mode?

Pages: [1]