Author Topic: Benbox carve mode outline polyline do not work with bmp.  (Read 358 times)

imatoso

  • Newbie
  • *
  • Posts: 1
    • View Profile
Benbox carve mode outline polyline do not work with bmp.
« on: November 19, 2016, 09:48:42 AM »

I was able to do once the figure of the Mario Bros in the benbox using outline polyline or curve, this configuration no longer works, the laser does not work with bmp figures, when I activate the delimiter it only makes the rectangle in the size of the figure. Someone with similar experience. Thank you, Ivo Nunes Brazil.

cottoncb

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Benbox carve mode outline polyline do not work with bmp.
« Reply #1 on: January 09, 2017, 06:44:49 AM »
This may not be your issue, but I have had to "open as administrator" in order to get it to work sometimes with BMP

Madmark

  • Jr. Member
  • **
  • Posts: 99
  • Do NOT look into beam with remaining good eye!
    • View Profile
Re: Benbox carve mode outline polyline do not work with bmp.
« Reply #2 on: January 11, 2017, 03:53:34 PM »
Try setting the .bmp DPI = 254 or 100 per cm

Make sure the sizes are multiples of 8.

M
GearBest A5 - 1600mW
LX-5 controller w/single MOSFET & GRBL jumper
Benbox 3.7.99
AutoCAD 2k .DXF
Ancient 2GB Dell Optiplex w/USB scanner

ed57

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Benbox carve mode outline polyline do not work with bmp.
« Reply #3 on: January 19, 2017, 10:56:12 AM »
I had the same problem, using Benbox version 3.7.99.  I loaded Benbox version 3.6.96 ,  and now the outline function works fine. My OS is windows 10.