Author Topic: 2 questions.  (Read 482 times)

rubberduck

  • Newbie
  • *
  • Posts: 6
    • View Profile
2 questions.
« on: November 30, 2016, 12:46:28 PM »
First in benbox software what is the size they are using or waht is the scale. Everything i have burned is super small.
Second question what is the button on top of the laser?

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 5742
    • View Profile
    • T2Laser
Re: 2 questions.
« Reply #1 on: November 30, 2016, 02:18:40 PM »
The scale is in mm, make sure you have the PPM values set correctly (320).

That's a popular question today, it restricts the power to a lower level perhaps to visualize / test the job or to help with focusing.

rubberduck

  • Newbie
  • *
  • Posts: 6
    • View Profile
Re: 2 questions.
« Reply #2 on: November 30, 2016, 02:29:13 PM »
Hey, thanks for the response. I have been looking and searching. Is their a video or something that helps with all the nitty gritty details. I have the 5500nm violet laser. I wouldn't mind switching to another software but  it almost sounds like the chinese. missing info or steps. I just wanna engrave some things. I can engrave but what should be 8inches is the size of a dime and deep


Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 5742
    • View Profile
    • T2Laser
Re: 2 questions.
« Reply #3 on: November 30, 2016, 02:55:07 PM »
The Chinese aren't much for documentation (at least the understandable kind) and most vendors have zero support.

This forum is probably the best source for information.