I've attached the 2xsvg files, I created in inkscape.
In page properties, i select A5 size, and white background.
Then when you export as png, make sure you have page selected, not selection, drawing, etc. and change dpi to 100pix/cm or 254dpi.
I've cut it onto 210GSM black card stock, at speed = 600, using carvemode = outline, continuous, laser.
Specifically, this is what I'm using bought from Officeworks here in Australia.http://www.officeworks.com.au/shop/officeworks/p/quill-xl-multiboard-210gsm-a5-black-50-pack-qu90701
Then just using blutack to hold them on the wall.
I have previosuly used vinyl book covering (contact) and you can set it to cut the vinyl but not the backing paper, but i can't remember my settings.