Author Topic: T2 Test version  (Read 208 times)

Eojuk

  • Newbie
  • *
  • Posts: 3
    • View Profile
T2 Test version
« on: January 04, 2017, 05:51:25 AM »
Hi
Hopefully I'm not asking the same question, I do apologise in advance if I have .

Yesterday I got my EleksMaker EleksLaser-A3 Pro 2500mW Laser Engraving Machine CNC Laser Printer (1003863)

The control buttons work but in the wrong directions.
Do I need a different firmware?
Thanks
Joe




Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3511
    • View Profile
    • T2Laser
Re: T2 Test version
« Reply #1 on: January 04, 2017, 06:05:41 AM »
Well that depends which firmware you are using  ;D ?

If you followed my conversion4.pdf document and have T2Laser v1.3t then you should be using Grbl 1.1e in which case you can reverse the axis in the menu.

Eojuk

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: T2 Test version
« Reply #2 on: January 04, 2017, 09:31:32 AM »
Well that depends which firmware you are using  ;D ?

If you followed my conversion4.pdf document and have T2Laser v1.3t then you should be using Grbl 1.1e in which case you can reverse the axis in the menu.

Hi Zax
I did follow your instructions, I've found the reverse the axis in the menu.
The 1st time I ran the software, the axis where ok. Don't know what I've done, so sorted now thanks
Joe