Author Topic: LaserAxe controller board is now Flashable  (Read 7852 times)

nc

  • Newbie
  • *
  • Posts: 34
  • "I am nothing special, just terribly curious."
    • View Profile
    • handmade jewelry and jewelry stands
Re: LaserAxe controller board is now Flashable
« Reply #15 on: February 20, 2017, 03:34:50 PM »
Woohoo!  Everything works.  Was able to get a small image engraved in wood before the trial limit ran out.  Just purchased T2L.  Thanks for the help everyone :)

Well done 👍
Stepan

A2+ (650x500mm) 2.3W TTL on Mana SE / ZAX's T2 Laser / Win7 (since 2017)
Benbox 7th generation (80x80mm) 300mW / Benbox v2.8.30 / WinXP (since 2014)
YOOCNC 6040Z-S65J (600x400mm) 800W, 3-axis / Artsoft Mach3 + Vectric Cut2D / WinXP (since 2015)

Designer using Adobe CS3 (since 2008)

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 5876
    • View Profile
    • T2Laser
Re: LaserAxe controller board is now Flashable
« Reply #16 on: February 20, 2017, 03:54:31 PM »
Good news, and thank you! I've sent your license code.

hiaviator

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: LaserAxe controller board is now Flashable
« Reply #17 on: February 20, 2017, 04:12:35 PM »
Good news, and thank you! I've sent your license code.

Received it and have an engraving running right now!  Easy to use and intuitive.  Good job!

iakovl

  • Newbie
  • *
  • Posts: 21
    • View Profile
Re: LaserAxe controller board is now Flashable
« Reply #18 on: March 11, 2017, 09:18:23 AM »
how to flash it?

PhiMX

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: LaserAxe controller board is now Flashable
« Reply #19 on: March 12, 2017, 06:05:37 AM »
Hi, are you aware that someone changed the pin mappings in grbl and made a fork for 0.9 and 1.1 grbl that works with our boards?
I just happened to fall into the same trap that many of you did when flashing the damn thing and as a way out I started to change grbl pin mappings to fit the controller.
Because thatīs all that there is.. just a tiny bit of different pin mapping on the laseraxe board.
While researching the pin mappings I found out that user 1wise already did the work and made a fork of grbl. I flashed it and it works.

grbl 1.1e for laseraxe board:
https://github.com/1wise/grblv1.1-laseraxe

grbl 0.9j for laseraxe board:
https://github.com/1wise/grbl-laseraxe-arduino-nanov3

enjoy!

and donīt forget to comment and tell me how it does!

PhiMX

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: LaserAxe controller board is now Flashable
« Reply #20 on: March 12, 2017, 06:06:19 AM »
... Iīll make a new thread for it!