Author Topic: -X and +x axis travel not equal  (Read 640 times)


  • Newbie
  • *
  • Posts: 17
    • View Profile
-X and +x axis travel not equal
« on: June 29, 2017, 12:53:53 PM »
when I make a long cut along the X axis I have noticed the -X travel is not equal to the +X distance.

when I make a multi-pass cut the line gradually moves in the +X direction.

this is when using BCL to make the cuts.

I have checked the tightness of the ratchet wheel on the motor as well as the belt.

not sure where to look next.


  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2170
    • View Profile
Re: -X and +x axis travel not equal
« Reply #1 on: June 29, 2017, 02:46:49 PM »
Check the current limits on the driver boards. Procedures in the sticky section or a good tutorial at
SARCASM - Just one more service we offer here.