How to set steps/mm in T2laser

[m-Kresol]

hey guys,
subject says it all. I need to adjust me steps/mm for the y axis. How do I send the command to the arduino using T2laser?

thanks,
Felix

[Zax]

Simple, use the built in calibration feature. Look on the Laser Controller in the Settings / Advanced menu.

[m-Kresol]

thanks Zax.

and how would you alter other parameters such as acceleration or max speed?

[Zax]

There's a setting for acceleration; default is 800 and reduced acceleration is 200.

You can send manual commands by enabling the debug option and typing them in the box.

Steps are $100 to 102, max speed is $110 to 112 and acceleration $120 to 122.

If you click Display Grbl Parameters you'll see them all and the defaults.

[m-Kresol]

There's a setting for acceleration; default is 800 and reduced acceleration is 200.

You can send manual commands by enabling the debug option and typing them in the box.

Steps are $100 to 102, max speed is $110 to 112 and acceleration $120 to 122.

If you click Display Grbl Parameters you'll see them all and the defaults.

Thank you. The debug option was exactly what I was looking for.