Author Topic: Upgrade suggestion  (Read 900 times)

patglazz

  • Newbie
  • *
  • Posts: 31
  • 55% of people are caused by accidents
    • View Profile
Upgrade suggestion
« on: November 16, 2017, 01:29:36 PM »
When doing a sketch I can set the X & Y to get a square (or rectangle), I make a lot of clocks and its quite time consuming designing them in gimp or inkscape then trying to position a circle of wood in a square, would it be possible to have the option to have a round page where instead of putting in X & Y I could just set R or D (radius or diameter). I know I can just make a circle and take it out before creating the Gcode, but when I do a trace with laser on it traces a square - it would be handy to have it trace in a circle.
Never too old to try something new...
...it just takes you longer to learn it

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7281
    • View Profile
    • T2Laser
Re: Upgrade suggestion
« Reply #1 on: November 16, 2017, 04:01:26 PM »
Interesting idea, but I'm not exactly sure how I would implement it.

I will add it to the list and give it some thought. Thanks!