Author Topic: Benbox will not "draw" in y-axis  (Read 439 times)

bryan2317

  • Newbie
  • *
  • Posts: 1
    • View Profile
Benbox will not "draw" in y-axis
« on: November 23, 2017, 09:30:51 AM »
So, i know the y-axis works because at the beginning of starting a new draw, the laser moves to the beginning point, and then begins, but it only cuts back and forth in the x axis.  It never moves down.


ggallant571

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2316
    • View Profile
Re: Benbox will not "draw" in y-axis
« Reply #1 on: November 23, 2017, 10:03:31 AM »
Which firmware?

Could be an insufficient power issue. One motor by itself works. Both at the same time fails.

Try vector cutting some simple shapes such as squares, triangles, and circles.
SARCASM - Just one more service we offer here.