Author Topic: Need help (OPEN)  (Read 1006 times)

ggallant571

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2171
    • View Profile
Re: Need help (OPEN)
« Reply #15 on: March 18, 2018, 09:10:27 AM »
New terminology to me. Are they 2D vectors?
SARCASM - Just one more service we offer here.

Administrator

  • Administrator
  • Hero Member
  • *****
  • Posts: 2742
  • Administrator
    • View Profile
Re: Need help (OPEN)
« Reply #16 on: March 18, 2018, 09:22:51 AM »
Yes, his dxf file was created with 2D Spline vector objects...
« Last Edit: March 18, 2018, 09:23:47 AM by Administrator »
Admin -- Ralph -- support @ BenCutLaser dot us
https://www.dropbox.com/s/qv1qee2vb65785t/SetupBenCutLaser3.2a.zip?dl=0
BCL Paid license: $49.95
via Paypal to bclpp@primemail.com

willy

  • Newbie
  • *
  • Posts: 12
    • View Profile
Re: Need help (OPEN)
« Reply #17 on: March 18, 2018, 04:31:30 PM »
I need to reproduce this bug in order to fix it.

Using the smallest number of drawing objects possible, can you give me the exact steps to make this happen? Then I can do exactly what you do and have a good chance of reproducing it and then fixing it.

Make sure you are using the latest BCL version.

Thanks...

Hi,

I am sorry not the speed cause that problems. i think number of pasess after dig more ..if i try to engrave 1 pass and laser head off and 2 times passes laser head. i attach the print screen

ggallant571

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2171
    • View Profile
Re: Need help (OPEN)
« Reply #18 on: March 18, 2018, 05:05:26 PM »
Looking at the gcode there appears to be very little travel (less than 0.5mm) between updates. Not sure if the poor Nano can sustain that for very long. Any option to make the curves less precise?
SARCASM - Just one more service we offer here.

Administrator

  • Administrator
  • Hero Member
  • *****
  • Posts: 2742
  • Administrator
    • View Profile
Re: Need help (OPEN)
« Reply #19 on: March 18, 2018, 05:30:39 PM »
Willy,

I still need steps to recreate your problem. I can't do much more until I get your exact steps to create this bug.

Also, you're still working on all of the drawing objects. We need to reduce this down to the minimum number of drawing objects that still gives us the bug.

George, to answer your question, see attachment. These values Willy may need to change if they are too high. The G-code Text dots per inch are also used for Spline drawing objects. I find 16 works well. Unless you have a lot of PC horse power, you don't need to use more than 16. Larger values produce more g-code, smaller values produce smaller g-code data. I try to match both of these values to 16.

Admin -- Ralph -- support @ BenCutLaser dot us
https://www.dropbox.com/s/qv1qee2vb65785t/SetupBenCutLaser3.2a.zip?dl=0
BCL Paid license: $49.95
via Paypal to bclpp@primemail.com