Linear edge fringe burn

[micky]

Hi all. I use by Eleksmaker A3 to engrave leather goods.

I use linear mode, which seems to cause a slight burn at the extreme ends of each engraving. You can see in my photos, the left side of the letter M, and the right side of the letter i are both darker than the rest of the engraving.

I can eliminate this by using diagonal mode, but that causes my machine to vibrate and as such I lose definition.

Can anyone suggest how I can eliminate this fringe burning but keep linear mode?

[ggallant571]

This can happen if the acceleration is too low. The newer firmware also has a laser mode where the intensity is diminished when traveling at less than the specified speed.

[wild.bill]

On the Laser page - Settings->Advanced->Dynamic Laser Power
enable that option

[Zax]

My default acceleration is pretty high so that's unusual (if you are using my Grbl 1.1e of course), but using the dynamic laser power option should fix it.

[micky]

Yes, I'm using your Grbl 1.1e.
I'll enable the dynamic laser power option and report back.
Thanks for the replies!

[micky]

It worked!
Thanks as always for your help fellas.
Mike.