Author Topic: Laser Engraver Upgrade  (Read 842 times)


  • Newbie
  • *
  • Posts: 36
    • View Profile
Laser Engraver Upgrade
« on: April 20, 2018, 07:34:49 AM »
Hi everyone. I had made a post a couple of weeks ago asking if anyone knew the belt size of a specific type of laser engraver. Thanks to Zax and mauriceman for their assistance with belt size info.

The unit has been upgraded and is working perfectly again. The original size was 17cm x 22cm and I upgraded to 60cm x 100cm. I also built a support above the gantry for the control board and cable management. It took a little fine tuning with spacers, washers, belt tightness, but it works great. Sorry the second image is a little blurry.


  • Sr. Member
  • ****
  • Posts: 376
    • View Profile
Re: Laser Engraver Upgrade
« Reply #1 on: April 20, 2018, 11:04:10 AM »

I recommend drag chain for cable management.