Author Topic: 3.2a Problem after pc format (CLOSED)  (Read 193 times)

joshua3

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
3.2a Problem after pc format (CLOSED)
« on: November 09, 2018, 02:39:56 AM »
Hi Ralph,

I have reinstalled BCL after formatting my PC (before format I was using 3.1e, which worked fine). I have just installed 3.2a and it is saying the laser is connected to my PC, I can hear a slight audible sound whine from the board, so I know it is connected. but I cannot move the laser, turn it on or anything else. I have flashed the controller to 1.1e at the correct baud and connected at the connect baud. I don't know what else to try. 3.1e worked fine on this pc.

Thanks
James
« Last Edit: November 09, 2018, 05:25:45 PM by Administrator »

joshua3

  • Jr. Member
  • **
  • Posts: 58
    • View Profile
Re: 3.2a Problem after pc format
« Reply #1 on: November 09, 2018, 04:49:07 AM »
I have just tried my laser on my old laptop running 2.5b and the laser/software are working fine. So it must be a problem with the formatted laptop.
Thanks

Administrator

  • Administrator
  • Hero Member
  • *****
  • Posts: 2793
  • Administrator
    • View Profile
Re: 3.2a Problem after pc format
« Reply #2 on: November 09, 2018, 05:25:32 PM »
OK thanks for the update.
Admin -- Ralph -- support @ BenCutLaser dot us
https://www.dropbox.com/s/qv1qee2vb65785t/SetupBenCutLaser3.2a.zip?dl=0
BCL Paid license: $49.95
via Paypal to bclpp@primemail.com