Author Topic: Swaping Y axis  (Read 318 times)

6Firewall6

  • Newbie
  • *
  • Posts: 14
    • View Profile
Swaping Y axis
« on: November 25, 2018, 08:59:27 PM »
I have tried to use this program with my Engraver and the Y access is set the wrong way for me. Is there any way in the program to swap the y axis? I know I can in T2  and in Elekcam . I have not tried any other software yet.
« Last Edit: November 25, 2018, 09:00:46 PM by 6Firewall6 »
2.5w laser A3 size
Mana SE board

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6346
    • View Profile
    • T2Laser
Re: Swaping Y axis
« Reply #1 on: November 26, 2018, 04:34:04 AM »
Use T2Laser to swap it and it'll remain swapped unless you change firmware, but if you want to do it manually you have to change the $3 parameter.

https://github.com/gnea/grbl/wiki/Grbl-v1.1-Configuration#3--direction-port-invert-mask