Author Topic: Loaded newest update now wont move  (Read 153 times)

btcrowe

  • Newbie
  • *
  • Posts: 8
    • View Profile
Loaded newest update now wont move
« on: December 02, 2018, 12:48:00 PM »
I just updated to the 1.5 T2 software from the 1.4d. Because I bought a new computer after my old one crashed. Now the laser will move using arrow buttons but once I load a g-code file and hit start the laser comes on, but just sits there, without moving. Any thoughts?

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6346
    • View Profile
    • T2Laser
Re: Loaded newest update now wont move
« Reply #1 on: December 02, 2018, 01:41:10 PM »
What controller and firmware are you using?

It sounds like the post processor is wrong for your machine but that is usually automatically set based on the firmware response.