Author Topic: EleksMana v 5.2 no longer working after Win 10 update - SOLVED  (Read 389 times)

aliraminghe

  • Newbie
  • *
  • Posts: 13
    • View Profile
Re: EleksMana v 5.2 no longer working after Win 10 update
« Reply #15 on: December 05, 2018, 11:29:23 PM »
You are right, it was just to show the laser board, my controller has a separate 12v connector.

My concern is if I definetly change to SainSmart controller keeping this laser should I attach the power cable (red/black) to laser connector and the signal one (green/yellow) to TTL connector?

Thanks for your great support.

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6346
    • View Profile
    • T2Laser
Re: EleksMana v 5.2 no longer working after Win 10 update
« Reply #16 on: December 06, 2018, 04:31:52 AM »
You can do that, it would be the same as using the 3 pin laser connector but as you have 2 separate plugs - that works.

aliraminghe

  • Newbie
  • *
  • Posts: 13
    • View Profile
Re: EleksMana v 5.2 no longer working after Win 10 update - SOLVED
« Reply #17 on: December 11, 2018, 01:15:45 AM »
swapped Eleksmaker Arduino clone with Hiletgo one, installed driver and 1.1 firmware, then sent parameters through T2Laser and at moment it works back perfectly even dimension are correct.
So definetly not a Win 10 issue.