Author Topic: Keeping small pieces cut from falling through the support grid  (Read 2038 times)

wveagle81

  • Full Member
  • ***
  • Posts: 180
    • View Profile
    • SpartanDragon Custom Laser Engraving
Keeping small pieces cut from falling through the support grid
« on: January 23, 2019, 12:03:29 PM »

I have made an air gap grid out of wire mesh from HomeDepot.  I created a frame using 1"x2"
strips and screwed them to a base.  Then I put the mesh over it and stapled it down.

Now, I'm concerned that when I cut out things which are smaller than the holes in the grid
(for inlays for example) that those pieces will fall through the grid and won't be able to get
them out.

How do you guys handle that situation?
***********************************
- Epilog 30W
- Mophorn 80W
- CorelDraw, Gimp, and Paint Shop Pro
- Obstacle Racer and Trail Runner