Author Topic: Replace nano  (Read 326 times)

donwatson

  • Full Member
  • ***
  • Posts: 178
    • View Profile
Replace nano
« on: November 26, 2019, 10:40:36 AM »
I had a bit of bad luck today and destroyed the connector on my Arduino. I replaced with the old Arduino but I think I have lost the control on the homing switches that I have fitted. Can I buy the new Arduino without buying the whole Eleksmaker Mana 3SE board ?? and who is the best supplier of these ??
Thanks
Don W

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7013
    • View Profile
    • T2Laser
Re: Replace nano
« Reply #1 on: November 26, 2019, 02:03:04 PM »
Yes, any Nano clone will work. Look for one with the boot loader already installed and then you can upload firmware and get back to lasering.


Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7013
    • View Profile
    • T2Laser
Re: Replace nano
« Reply #3 on: November 27, 2019, 04:56:48 AM »
Yes, they look fine.

donwatson

  • Full Member
  • ***
  • Posts: 178
    • View Profile
Re: Replace nano
« Reply #4 on: November 27, 2019, 05:24:20 AM »
Thanks Zax, I will order now.

take care
Don W

donwatson

  • Full Member
  • ***
  • Posts: 178
    • View Profile
Re: Replace nano
« Reply #5 on: November 30, 2019, 03:29:43 AM »
Hi Zax,
The pack of 3 replacement Arduinos arrived yesterday and they are (look) the same as the replacement I fitted from the old board. I did get back to lasering and this was the result. Just the clock to fit to the centre of the piece and !voila!
Thanks again
Don W
 

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7013
    • View Profile
    • T2Laser
Re: Replace nano
« Reply #6 on: November 30, 2019, 05:41:17 AM »
Great news and memories for me from when my parents lived in Gullane.

donwatson

  • Full Member
  • ***
  • Posts: 178
    • View Profile
Re: Replace nano
« Reply #7 on: December 01, 2019, 06:31:16 AM »
Aye, as big as Texas is, it has nothing like these beauties. lol