Replace nano

[donwatson]

I had a bit of bad luck today and destroyed the connector on my Arduino. I replaced with the old Arduino but I think I have lost the control on the homing switches that I have fitted. Can I buy the new Arduino without buying the whole Eleksmaker Mana 3SE board ?? and who is the best supplier of these ??
Thanks
Don W

[Zax]

Yes, any Nano clone will work. Look for one with the boot loader already installed and then you can upload firmware and get back to lasering.

[donwatson]

Thanks Zax. Will have a look around. I have fitted the Arduino from the board that was replaced, I think that may work.

Will this be ok ??

https://www.amazon.co.uk/diymore-ATmega328P-controller-CH340G-Arduino/dp/B07DCKC3TX/ref=sr_1_2_sspa?crid=3IXFEI59M97M5&keywords=arduino+nano&qid=1574855888&sprefix=arduino%2Caps%2C178&sr=8-2-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzUU4wOUQwWVpZSDRMJmVuY3J5cHRlZElkPUEwNjE2MTg5T1RPV0FMVEVMREZCJmVuY3J5cHRlZEFkSWQ9QTAxNDcwMzUxV1ZGRUk1QURLWkg4JndpZGdldE5hbWU9c3BfYXRmJmFjdGlvbj1jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ==

[Zax]

Yes, they look fine.

[donwatson]

Thanks Zax, I will order now.

take care
Don W

[donwatson]

Hi Zax,
The pack of 3 replacement Arduinos arrived yesterday and they are (look) the same as the replacement I fitted from the old board. I did get back to lasering and this was the result. Just the clock to fit to the centre of the piece and !voila!
Thanks again
Don W
 

[Zax]

Great news and memories for me from when my parents lived in Gullane.

[donwatson]

Aye, as big as Texas is, it has nothing like these beauties. lol