Author Topic: Wife got a engraver for XMas...  (Read 104 times)

jmarsden92

  • Newbie
  • *
  • Posts: 2
    • View Profile
Wife got a engraver for XMas...
« on: December 30, 2019, 08:52:24 PM »
I bought my wife a engraver for XMas.
It has
NANO
DCCduino
printed on the outer chip

I run T2 but it only allows printing of a few lines when I import a picture...
Is this because it is in demo mode?

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7013
    • View Profile
    • T2Laser
Re: Wife got a engraver for XMas...
« Reply #1 on: December 31, 2019, 04:19:19 AM »
It sounds like you bought yourself a laser for Xmas  ;D

The trial is limited to 10,000 lines of G-code, which using a resolution of 0.15 to 0.2 should be sufficient for testing that everything works correctly. The registered version removes all restrictions of course, currently $39.95 if purchased from the trial ($5 discount).