Author Topic: Question...  (Read 145 times)

jmarsden92

  • Newbie
  • *
  • Posts: 2
    • View Profile
Question...
« on: January 08, 2020, 07:16:43 PM »
I have a 65x50 cm laser engraver with blue laser...  the board is a DCCduino...  It has a 2 wire connector on the board that leads to the laser power module...  I just purchased a eleksmaker mana se.  I wanted to go to that board, but the laser is a 3 wire on the board...  suggestions?

ggallant571

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2983
    • View Profile
Re: Question...
« Reply #1 on: January 08, 2020, 08:07:24 PM »
I believe the 2-pin header labeled MOTOR on the SE is the PWM switched power for connecting to 2-wire diode modules.
SARCASM - Just one more service we offer here.

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6939
    • View Profile
    • T2Laser
Re: Question...
« Reply #2 on: January 09, 2020, 04:18:08 AM »
Correct.