Author Topic: Using T2 with an Eleksrotate module (Read 2740 times)

bnaivar · « **on:** January 13, 2021, 06:50:12 AM »

I got an Eleksrotate module from the wifey for Christmas. Are there any settings in T2 that I need to change for engraving using this module? On the tests that I have done so far, the engraving appears to be oval instead of round.

Zax · « **Reply #1 on:** January 15, 2021, 02:08:40 PM »

No, the Eleks Rotate does not require any changes. Some other rotary modules do need to use the rotary mode option to change settings but not this type of rotary.

bnaivar · « **Reply #2 on:** January 15, 2021, 03:59:27 PM »

So do I just need to compensate manually for the oval distortion?

Zax · « **Reply #3 on:** January 17, 2021, 10:12:35 AM »

It should not be distorted unless it's because of the taper. The Eleks Rotate method moves the rollers at the same steps per mm as the normal Y-axis so the object should also move at the same rate / distance.

bnaivar · « **Reply #4 on:** January 17, 2021, 01:02:33 PM »

Thanks!

ThothLoki · « **Reply #5 on:** January 17, 2021, 04:37:24 PM »

I see two potential issues

1. The mug is slipping on the rotary

2. Your stepper driver current is too high. The y axis has two motors and the driver is calibrated for two motors. How you have only one.

bnaivar · « **Reply #6 on:** January 18, 2021, 07:44:08 AM »

I never thought about the driver current. Thank you.

Benbox Laser Machines/CO2 Lasers/3D Printers

News:

Author Topic: Using T2 with an Eleksrotate module (Read 2740 times)

bnaivar

Using T2 with an Eleksrotate module

Zax

Re: Using T2 with an Eleksrotate module

bnaivar

Re: Using T2 with an Eleksrotate module

Zax

Re: Using T2 with an Eleksrotate module

bnaivar

Re: Using T2 with an Eleksrotate module

ThothLoki

Re: Using T2 with an Eleksrotate module

bnaivar

Re: Using T2 with an Eleksrotate module