Hi All,
I have been asked if I could engrave the top of a wooden box with a picture and a name. I have a picture of an Iris that is to go on the box and the name ready at the sizes I want. I have tried Sketch in T2 but can't seem to find out how to do it. The top of the box is 270 mm x 200 mm. The iris is around 170 mm x 95 mm and the name is Janette in MS Comic font. i would like the name to be about 150 mm long and around 40 mm high although anything will do as long as it looks ok. I have attached a pic of what I hope to achieve so if anyone can help me get this project running I would be very grateful. I need to know how to attach a picture to Sketch after I have the name on, I will attach what I have save so far. Thanks again.
