Author Topic: Help in getting T2 Software to work?  (Read 1702 times)

superninja

  • Newbie
  • *
  • Posts: 1
    • View Profile
Help in getting T2 Software to work?
« on: August 07, 2016, 06:40:56 PM »
Hello Everyone,

I'm new and I have a 2.5 Watt engraver from Banggood.  I downloaded the trial software for T2.  I really like it, but not sure how to use it.  I read the manual, uploaded a simple picture. I generated the G-Code and then it goes to the laser controller.

Is there a button that will start the laser design engraving?  Both the laser on and laser pulse will turn the laser on and burn it, but it does not move left right or up and down for the design.  Is there a play button like the benbox software? 

Any help would be great.

Thanks!

Is there something you have to do other than just install the software?  Is there a button I'm missing?

TBN

  • Full Member
  • ***
  • Posts: 106
    • View Profile
    • Traditional By Nature
Re: Help in getting T2 Software to work?
« Reply #1 on: August 07, 2016, 07:55:50 PM »
Just click send.
500mw A5 Mini Laser Engraving Machine from GearBest

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7302
    • View Profile
    • T2Laser
Re: Help in getting T2 Software to work?
« Reply #2 on: August 08, 2016, 05:24:19 AM »
Someone suggested I make a huge GREEN button to go with the red one so it was more obvious, but once you get used to my crazy software you'll love it  ;D