Author Topic: help delta kossel configuration  (Read 1080 times)

kibodwin

  • Hero Member
  • *****
  • Posts: 644
    • View Profile
help delta kossel configuration
« on: September 23, 2016, 12:36:52 PM »
anyone here got a kossel style delta? i have some questions about the configuration....
Laser: 2500mw A5 eleksmaker L5, K40 with Cohesion3D mini board, air assist, laser pointer etc..
OS: Windows 7, Debian, OpenSuse, Kali
Software: T2Laser, laserweb4, Repitier, Cura
Prusa i3 Clone GT2560
Anycubic Kossel Delta ramps

DIMM2

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: help delta kossel configuration
« Reply #1 on: January 10, 2017, 06:49:31 AM »
I'm here. :-)
"Anycubic Linear DIY Kit Kossel Delta" was buyed about two weeks ago and already assembled, adjusted, tuned and slightly modded. :-)
But I'm not expert so I will only try to answer possible questions.

kibodwin

  • Hero Member
  • *****
  • Posts: 644
    • View Profile
Re: help delta kossel configuration
« Reply #2 on: March 22, 2017, 04:08:31 AM »
Hi Dimm2,
Sorry about the delay in replying, life sort of got in the way!
I am working at getting the anycubic kossel printer working and right now I am stuck with the endstops not 'working' as they should.
When I ask the printer to go to 'home' in Repitier all that happens is that each 'x', 'y' and 'z' carriage goes down 1Cm one at a time and not, as I would have expected to go all the way up and engage the endstops.
Do you think you could share your config.h so I can see the endstop setting you use and compare them to mine? I think it is a config issue. If you dont mind a picture of the wiring you use on the endstops would also be of great help.
Thanks,
Ki
=)
Laser: 2500mw A5 eleksmaker L5, K40 with Cohesion3D mini board, air assist, laser pointer etc..
OS: Windows 7, Debian, OpenSuse, Kali
Software: T2Laser, laserweb4, Repitier, Cura
Prusa i3 Clone GT2560
Anycubic Kossel Delta ramps