Benbox Laser Machines/CO2 Lasers/3D Printers

Software => EleksDraw => Topic started by: SteveK on February 04, 2018, 05:41:37 AM

Title: Mana se drivers
Post by: SteveK on February 04, 2018, 05:41:37 AM
I have an eleksmaker A3 with the nano controller. I'm trying to build a new machine and the controller I have for that is a mana se. Do I need to install different drivers for that controller?

Steve
Title: Re: Mana se drivers
Post by: Zax on February 04, 2018, 07:52:53 AM
Probably not, most of the Chinese boards use the same CH340 UART chip.

The original Arduino used an FTDI chip which in my opinion is far superior, just like the genuine Atmel is better than the Chinese knock-off that has memory glitches when it gets hot.
Title: Re: Mana se drivers
Post by: SteveK on February 04, 2018, 05:20:06 PM
thx!!

Steve