Benbox Laser Machines/CO2 Lasers/3D Printers

General Category => General Discussion => Topic started by: mattm58 on May 01, 2018, 10:55:38 PM

Title: Need help with weak power to focus
Post by: mattm58 on May 01, 2018, 10:55:38 PM
Ok, I picked up a another A3 secondhand.  It's got a mana se board, and a 2 wire 2.5w laser.  I've got it working, but with one gotcha.  I can't figure out how to get it to low power for focusing the laser.  My other A3 has the low power button on the laser, and I've seen other boards that have a low power button on the controller, but this setup has neither.

I'm using T2 because Zax is the man...
Title: Re: Need help with weak power to focus
Post by: Zax on May 02, 2018, 04:46:49 AM
 ;D

On my non-TTL (2 wire) laser I just set the manual laser power to 50 and turn it on.