Benbox Laser Machines/CO2 Lasers/3D Printers

Sellers From => Makeblock => Topic started by: Super Mekah on December 10, 2018, 09:40:16 AM

Title: MAKEBLOCK X, Y plotter V2
Post by: Super Mekah on December 10, 2018, 09:40:16 AM
Any one else using a Makeblock?
I'm getting very good gray tone photo results Using Zac's T2Laser.
Using Benbox 3.7.99, firmware makeblock-328p-20150606.hex.
Hardware:
ORION (UNO) controller, weird output mapping.
20 A P.S. Buck type VR.
laser 2.8 watt (from George F.) early 2.1 el-cheapo with my own heat sink.
Russian made laser controller (Simpledrive Ix6A) driver. Very adaptable and adjustable.
Redundant driver amperage control. Old school resistive with temp sensor in parallel with above.

 Time to burn one!