Benbox Laser Machines/CO2 Lasers/3D Printers
General Category => General Discussion => Topic started by: Hokuro on January 08, 2019, 11:39:08 AM
-
hi guys,
I'm Simone from Italy and I recently got a laser engraver 50x 56 3W
LASER (https://www.banggood.com/it/5065cm-Engraving-Area-3000MW-Laser-Engraving-Machine-DIY-Kit-Desktop-Laser-Cutting-p-1268114.html?rmmds=search&cur_warehouse=CN)
and now I'm studying on your beautiful forum. I did several tests, many failures ... good results with the b / w discrete with dithering and bad with the gray scale.
MY WORK (https://photos.app.goo.gl/9cPFaPNkJ5F8T9zj8)
I loaded gbrl 1.1f and use lasergbrl, I also tried t2laser trial but it is still too complicated for my skills.
-
Looking at the picture your laser isn't a TTL (only has 2 wires) so grey scale isn't likely to be very good and probably best avoided.
You can use velocity mode or dithered to get similar results.