Benbox Laser Machines/CO2 Lasers/3D Printers

General Category => General Discussion => Topic started by: Hokuro on February 04, 2019, 12:13:24 PM

Title: laser stove :)
Post by: Hokuro on February 04, 2019, 12:13:24 PM

Hi guys,
I read a lot of threads and I became paranoid: my laser was resting on a chipboard and needed continuous surveillance.
Now I have created this "monster" and I can leave the laser to work alone.
In the worst case the garage is heated.
It's not very nice but I make it with scraps. I have a lot of scraps...
I hope you like it.

Title: Re: laser stove :)
Post by: ggallant571 on February 04, 2019, 01:11:00 PM

Did you mean to attach a picture?

Title: Re: laser stove :)
Post by: kibodwin on February 05, 2019, 02:14:14 AM

Is this a special method of heating your tea with a laser... I am interested!!
=)

Title: Re: laser stove :)
Post by: Hokuro on February 05, 2019, 02:49:11 AM

Sorry, is one week that I have problems to access the forum from the desktop PC "the site is not responding" and I have to use an anonymous site that misses the formatting.

Title: Re: laser stove :)
Post by: ggallant571 on February 05, 2019, 06:00:55 AM

@kibodwin - You have it wrong!!. The laser is for etching your initials in the tea leaves.

Title: Re: laser stove :)
Post by: kibodwin on February 06, 2019, 03:12:52 AM

typical, I always get the wrong end of the stick!!

cool container, I would advice some good extraction as the smoke will mess with the pc you have in the container...
How about adding a webcam to monitor the laser when in use?
=)

Title: Re: laser stove :)
Post by: Hokuro on February 06, 2019, 04:28:54 AM

work in progress.
extractor and webcam to be mounted, yesterday I received from China the powerlan to remote control, I'm waiting for ip-relais to remotely control the power of the laser.
the monitor is outside the box, it was inside only for the works